USB-C AVR ISP programmer · ATmega8A + USBasp firmware · 1.8-5.5 V level shifting · open hardware by ElectroIoT
Design stage. Planned design, not a finished schematic or PCB and not built yet: nets come from tools/data.py, pin numbers of U1, U4, U5 were read from the datasheets, but every symbol and footprint must still be checked in EasyEDA.
What is new in V6
USB-C
16-pin USB 2.0 receptacle with separate 5.1 k on CC1 and CC2: works with USB-C to USB-C cables, laptops and phone chargers.
Safe 1.8 - 5.5 V targets
74LVC8T245 + 74LVC1T45 level shifter powered from the target's own VCC: no more 5 V signals into a 3.3 V chip.
Pins released when idle
The shifter outputs are only on while the red BUSY LED is lit, so the programmer does not fight the target's own use of MOSI / SCK / RST.
Protected target power
Jumper for 5 V / 3.3 V / off, 200 mA PTC fuse and a yellow LED: a shorted target no longer resets the programmer or the PC port.
USB protection
500 mA PTC on VBUS and a USBLC6 ESD diode array on D+ / D-.
10-pin AND 6-pin ISP
Keyed box header for the standard 10-pin cable plus the 6-pin Arduino ICSP layout, as asked in the v5 comments.
Easy firmware update
A separate 6-pin header (J4) to flash the board's own ATmega8A; no more jumper juggling on the ISP header.
Stock firmware
Runs the original USBasp 2011-05-28 firmware unchanged and works with avrdude (-c usbasp) and the Arduino IDE.
Design pages
Bill of materials: 45 parts, about USD 4.01, LCSC numbers, copy-all button.
Wiring by section: connection map, ATmega8A pin table, every pin-to-net per part.
Schematic by section: three sheets, build steps, ATmega8A / level-shifter / USB-C pin guides.
PCB floorplan: 84 x 32 mm board, block boxes, X / Y position of every part.